This page was exported from Download MCSE New Exam Questions From PassLeader [ http://www.mcsebibles.com ] Export date:Tue Nov 20 6:16:40 2018 / +0000 GMT ___________________________________________________ Title: [New Exam Dumps] Practice PassLeader New 137q 642-997 Dumps To Pass Exam Quickly --------------------------------------------------- New Updated 642-997 Exam Questions from PassLeader 642-997 PDF dumps! Welcome to download the newest PassLeader 642-997 VCE dumps: http://www.passleader.com/642-997.html (137 Q&As) Keywords: 642-997 exam dumps, 642-997 exam questions, 642-997 VCE dumps, 642-997 PDF dumps, 642-997 practice tests, 642-997 study guide, 642-997 braindumps, Implementing Cisco Data Center Unified Fabric (DCUFI) Exam NEW QUESTION 101 If you are using NAT in your data center, which load balancing would you be likely to use within your GLBP configuration? A.    none B.    round-robin C.    host dependent D.    weighted Answer: C NEW QUESTION 102 Which command specifies a load-balancing method based on the MAC address of a host where the same forwarder is always used for a particular host while the number of GLBP group members remains unchanged? A.    load-balancing host-dependent B.    load-balancing mac-pinning C.    load-balancing round-robin D.    load-balancing weighted Answer: A NEW QUESTION 103 Which feature allows routing protocols to remain in the data path during a supervisor failover? A.    Cisco Nonstop Forwarding B.    Cisco Stateful Switchover C.    Cisco Express Forwarding D.    Cisco Route Processor Redundancy Answer: A NEW QUESTION 104 Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.) A.    the ability to attach Cisco Fabric Extenders in FEX active/active mode B.    the ability to stop all Layer 3 egress traffic C.    the ability to attach servers to edge switches with port-channel teaming D.    the ability to attach additional Classic Ethernet switches in vPC+ mode Answer: AC NEW QUESTION 105 How does addition of bandwidth between spine and leaf switches in a FabricPath architecture get utilized? A.    Links between the same set of switches are automatically added to a port channel. B.    Adding additional bandwidth is handled dynamically using the 802.1AX protocol. C.    Traffic is load shared automatically across the available paths to the destination. D.    FabricPath uses hardware bonding of physical interfaces to form higher-speed links. Answer: C NEW QUESTION 106 Which two advantages does FabricPath have over Spanning Tree in implementing a loop-free network topology design? (Choose two.) A.    Blocked links can be brought in to service if active links fail. B.    Convergence times are faster. C.    Multipath forwarding is supported for unicast and multicast Layer 2 and Layer 3 traffic. D.    Unknown unicast addresses are flooded in through the originating port. Answer: BC NEW QUESTION 107 Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.) A.    The range of reserved VLANs cannot be changed. B.    The number of reserved VLANs is 96. C.    A change to the range of reserved VLANs can be performed only in the VDC default. D.    A write-erase procedure restores the default reserved VLAN range. E.    The number of reserved VLANs is 128. F.    A reload is needed for changes to take place. G.    The configuration must be saved for changes to take place. Answer: CEFG NEW QUESTION 108 Which two RFCs are supported by Cisco NX-OS devices for OSPFv2? (Choose two.) A.    RFC 2238 B.    RFC 1918 C.    RFC 1583 D.    RFC 2453 E.    RFC 2740 Answer: AC NEW QUESTION 109 Which action limits the maximum number of routes that are allowed in the routing table? A.    Use a filter BGP. B.    Use only static routes. C.    Use the maximum routes command inside address family. D.    Use a route map to filter routes. Answer: C NEW QUESTION 110 Which three options of encryption are supported in PIM hello messages? (Choose three.) A.    cleartext B.    DES-SHA1 C.    DES-CBC3-SHA D.    Cisco Type 7 E.    RC4-SHA F.    3DES Answer: ADF NEW QUESTION 111 Which command is used to associate EID-to-RLOC for a LISP site? A.    #feature lisp B.    #ipv6 lisp itr C.    #ip lisp database-mapping D.    #ip lisp itr map-resolver Answer: C NEW QUESTION 112 In OTV, how are the VLANs split when a site has two edge devices? A.    They are configured manually by user. B.    They are split in half among each edge device. C.    They are split as odd and even VLAN IDs on each edge device. D.    It is not possible to have two edge devices in same site. Answer: C NEW QUESTION 113 Which statement about the MPLS feature set is true? A.    It is not license dependent. B.    It can be installed from any VDC. C.    It can be enabled only in the default VDC. D.    It must be installed from the default VDC. Answer: D NEW QUESTION 114 ...... Download the newest PassLeader 642-997 dumps from passleader.com now! 100% Pass Guarantee! 642-997 PDF dumps & 642-997 VCE dumps: http://www.passleader.com/642-997.html (137 Q&As) --------------------------------------------------- Images: --------------------------------------------------- --------------------------------------------------- Post date: 2015-12-04 09:32:02 Post date GMT: 2015-12-04 09:32:02 Post modified date: 2015-12-04 09:32:02 Post modified date GMT: 2015-12-04 09:32:02 ____________________________________________________________________________________________ Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from www.gconverters.com